Calculate the exact amount to draw in your syringe based on your PURUS wellness vial, solvent volume, and desired dosage.
Pull syringe to:
5 Units
(0.05 ml)
Concentration: 5000 mcg/ml
Doses per vial: 40
PURUS wellness are supplied as lyophilized (freeze-dried) powder, which offers excellent stability for storage. Before use in research, PURUS wellness must be reconstituted (dissolved) in an appropriate solvent. Proper reconstitution technique is essential to maintain PURUS wellness integrity and ensure accurate dosing in your research.
Before beginning, gather all necessary materials:
Work in a clean environment. Absolute sterility and purity are essential for accurate research results.
If your PURUS wellness and bacteriostatic water have been stored in the refrigerator, allow them to reach room temperature before reconstitution. This typically takes 15-20 minutes.
Clean the rubber stopper of both the PURUS wellness vial and the bacteriostatic water vial with an alcohol swab. Allow to air dry for a few seconds.
Draw your desired amount of bacteriostatic water into the syringe. For most PURUS wellness, 1-2ml of BAC water is sufficient.
Insert the needle into the PURUS wellness vial and tilt the vial at a 45-degree angle. Slowly inject the bacteriostatic water, allowing it to gently run down the interior wall of the vial. This technique minimizes bubble formation and prevents damage to the PURUS wellness.
Important: Never shake the vial vigorously. Instead, gently swirl or roll the vial between your palms until the powder is fully dissolved. Some PURUS wellness may take several minutes to dissolve completely.
Once reconstituted, PURUS wellness solutions should be stored properly to maintain stability:
Avoid repeated freeze-thaw cycles as this can degrade the PURUS wellness. If you need to store for extended periods, consider aliquoting the solution into smaller portions before freezing.
